Specifications And Approvals; Specifications; M501-Trs Specifications; Epa Equivalency Designation - Teledyne T102 Operation Manual

2. SPECIFICATIONS AND APPROVALS

2.1. Specifications

2.1.1. M501-TRS Specifications

Minimum Converter Efficiency
Maximum TS Concentration for
specified conversion efficiency
Sample Flow Rate
Optimum Converter
Temperature
Maximum Converter
Temperature
Dimensions H x W x D
Weight
AC Power Rating
Internal Alarms
Alarm Output Relay
Alarm Output Rating
Environmental
Certifications
For indoor use at altitudes ≤ 2000m only

2.2. EPA Equivalency Designation

07267B DCN6485
As there are no significant differences between the performance specifications for the
T102 and the T101 please refer to in the Specification section of the T101 Manual - PN
07266. However, the AC power specifications for the T102 are as follows:
T102 AC Power: 100V – 120V, 60Hz (200W); 220V – 240V, 50Hz (211W)

Table 2-1: Model 501 Basic Unit Specifications

H S >95%
2
COS >90%
CS >90%
2
20 ppmv
650cc/min. ±10% - driven by T102 pneumatic system
850°C (factory setup)
1100°C
7" x 17" x 23.5" (178 mm x 432 mm x 597 mm)
16 lbs (7.3 kg)
26 lbs (11.8 kg) CE version
115 V, 50/60 Hz - 400 Watts;
230 V, 50/60 Hz - 575 Watts; CE Version
High Alarm Point:
Low Alarm Point:
SPST - 1 point: Alarm output is energized should either the temperature
controller's high or low internal alarm set points be activated.
220V AC/30V DC, 1A (resistive load)
Installation category (over-voltage category) II; Pollution degree 2
IEC 1010-1 / 61010-1:93 (includes A1) + A2:95,
No EPA equivalency standards exist for TRS measurement, however, the T102 analyzer
qualifies for EPA equivalency designation as Reference Method Number EQSA-0495-
100 per 40 CFR Part 53 when operated under the following conditions:
Measurement Mode: SO
•
900°C
800°C
single gas mode.
2
15