Introduction, Specifications, Approvals, & Compliance; Specifications; Table 1-1. Specifications - Teledyne T200 User Manual

INTRODUCTION, SPECIFICATIONS, APPROVALS, &
1.
COMPLIANCE
Teledyne API's Model T200 (also referred to as T200) NO/NO
chemiluminescence detection (see Principles of Operation, Section 6, this manual),
coupled with state-of-the-art microprocessor technology to provide the sensitivity, stability
and ease of use needed for ambient or dilution CEM monitoring requirements of nitric
oxide (NO), nitrogen dioxide (NO
high accuracy and dependability, the T200 tracks operational parameters and issues
warnings if they fall outside diagnostic limits, as well as stores easily retrievable data.
Proprietary software allows configurable data acquisition capability that can be triggered
conditionally or periodically, enabling operators to perform predictive diagnostics and
enhanced data analysis by tracking parameter trends. Reports can be downloaded onto a
USB flash drive or via the I/O ports. Operators can also view real-time graphing with one
touch of the interface screen.

SPECIFICATIONS

PARAMETER
Min/Max Range
(Physical Analog Output)
Measurement Units
Zero Noise 1
Span Noise 1
Lower Detectable Limit
Zero Drift
Span Drift
Lag Time 1
Rise/Fall Time 1
Linearity
Precision
Sample Flow Rate
AC Power
Analog Output Ranges
Analog Output Resolution
Recorder Offset
083730200A DCN7962
) and total nitrogen oxides (NO
2

Table 1-1. Specifications

Min: 0-50 ppb Full Scale
Max: 0-20,000 ppb Full Scale (selectable, dual ranges supported)
ppb, ppm, µg/m 3
< 0.2 ppb (RMS)
< 0.5% of reading (RMS) above 50 ppb
2 0.4 ppb
< 0.5 ppb (at constant temperature and voltage) /24 hours
< 0.5% of Full Scale (at constant temperature and voltage) /24 hours
20 seconds
< 60 seconds to 95%
1% of full scale
0.5% of reading above 50 ppb
500 cc/min ± 10%
110-120 V~, 60 Hz, 3.0 A
220-240 V~, 50/60 Hz, 3.0 A
10V, 5V, 1V, 0.1V (selectable)
All Ranges with 5% Under/Over Range
1 part in 4096 of selected full-scale voltage
± 10%
Teledyne API T200 NO/NO
SPECIFICATION
, mg/m 3 (selectable)
Rating
100 W
110 W
/NO Analyzer with NumaView™ Software
2 x
/NO Analyzer uses
2 X
). Along with providing
x
Typical Power Consumption
15