Specifications, Approvals & Compliance; Specifications And Approvals; Table 2-1 T100 Basic Unit Specifications - Teledyne t100 Operation Manual

2.
SPECIFICATIONS, APPROVALS & COMPLIANCE
2.1.

SPECIFICATIONS AND APPROVALS

Table 2-1 T100 Basic Unit Specifications

Parameter
Ranges
(Physical Analog Output)
Measurement Units
1
Zero Noise
1
Span Noise
2
Lower Detectable Limit
Zero Drift
Span Drift
1
Lag Time
1
Rise/Fall Time
Linearity
1
Precision
Sample Flow Rate
Power Requirements
Analog Output Ranges
Recorder Offset
Standard I/O
Optional I/O
06807F DCN7335
This section presents specifications for the T100 analyzer and the O
options, Agency approvals, EPA equivalency designation, and CE mark compliance.
Min: 0-50 ppb Full Scale
Max: 0-20,000 ppb Full Scale (selectable, dual ranges and auto ranging supported)
3
ppb, ppm, µg/m , mg/m
0.2 ppb (RMS)
<
0.5% of reading, above 50 ppb
<
0.4 ppb
0.5 ppb/24 hours
<
0.5% of full scale/24 hours
<
20 seconds
<100 sec to 95%
1% of full scale
0.5% of reading above 50 ppb
650 cc/min. ±10%
Power Rating
110-120 V~, 60 Hz 3.0A
220-240 V~, 50/60 Hz 3.0A
10 V, 5 V, 1 V, 0.1 V (selectable)
± 10 %
1 Ethernet: 10/100Base-T
2 RS-232 (300 – 115,200 baud)
2 USB device ports
8 opto-isolated digital outputs
6 opto-isolated digital inputs
4 analog outputs
1 USB com port
1 RS485
8 analog inputs (0-10V, 12-bit)
4 digital alarm outputs
Multidrop RS232
3 4-20mA current outputs
Description
3
(selectable)
and CO
2
Typical Power Consumption
165W
140W
sensor
2
23