Multi-Channel Support - Siemens SINUMERIK 828D Commissioning Manual

Feedrate
SD42600 $SC_JOG_FEED_PER_REV_SOURCE = -3
SD43300 $SA_ASSIGN_FEED_PER_REV_SOURCE [X ax‐
is] = -3
SD43300 $SA_ASSIGN_FEED_PER_REV_SOURCE [Z ax‐
is] = -3
Note
Ensure that the axis-specific setting data SD43300 SA_ASSIGN_FEED_PER_REV_SOURCE
are set the same.
References
● Operating:
Operating Manual, Turning/Milling, Chapter "Working with a manual machine"
● Programming:
Programming Manual, Fundamentals; Chapter "Working area limit"
5.9

Multi-channel support

In the "Machine" operating area, a dual channel view is possible for any two channels (2 from
n) of a mode group.
Using the multi-channel editor, for a multi-channel machine, you can open, change or generate
programs simultaneously that are independent of one another from a time perspective. In this
case, the programs involved are displayed next to one another in the editor.
Further, you have the option of simulating the programs before they are actually processed at
your control.
In addition, you can align the programs according to synchronization points.
Note
The multi-channel support is supported only for the turning and grinding technologies with the
following CNC software variants:
● PPU 280/281 System Software Turning advanced
● PPU 280/281 System Software G-Tech advanced
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Customizing the "Machine" operating area
5.9 Multi-channel support
Revolutional feedrate control in JOG
mode
Revolutional feedrate for positioning
axis X
Revolutional feedrate for positioning
axis Z
61