Initialization Procedure Of The System - NEC Univerge SV8500 Operation And Maintenance Manual

3. INITIALIZATION PROCEDURE OF THE SYSTEM

3.1 General
This section explains how to initialize the system. The following can be used:
• PCPro (SINZ)
• PCPro Tools (System Control - System Reboot)
• By INIT key Operation on EMA card
• By Turning OFF/ON the System
When the system is initialized, all calls in progress will be disconnected.
WARNING
System initialization can be roughly divided to "Non Load Initial" and "Load Initial." The former reboots the
system using the program and office data that are currently loaded in the memory. On the other hand, the latter
loads the office data (and program) into the memory before rebooting the system. After loading the data into the
memory, system initialization will take place. Available initialization types vary depending on type of
operations.
Non Load Initial
MEM
- Office Data
- Program
Initialization
CHAPTER 2
CF Card
load
- Office Data
- Program
– 47 –
Operations of SV8500 Server
Load Initial
MEM
- Office Data
Initialization
- Program