NEC Univerge SV8500 Operation And Maintenance Manual page 119

STEP 4 Remove the front cover.
STEP 5 Remove the CF card from the CPU card.
STEP 6 Loosen the screws from the CPU card.
STEP 7 Pull the CPU card slowly toward you to remove from the system.
STEP 8 On the new CPU card, set the switches exactly same as those of the old CPU card.
STEP 9 Insert the new CPU card to the CPU slot.
• Make sure that the connector is firmly inserted to the system.
STEP 10 Fasten the new CPU card with the screws.
STEP 11 Insert the removed CF card to the slot.
STEP 12 Attach the front cover again.
STEP 13 Reconnect the LAN cables.
STEP 14 Turn on the PIR (s) and TSWR when they are accommodated. If not skip this step.
<For 1-IMG>
Turn on the power (PWR/DPWR cards) in the following order.
• PIR0 PIR1 PIR2 PIR3 (smaller number PIR first)
<For 4-IMG>
Turn on the power (PWR/DPWR cards) in the following order.
• TSWR
• PIR0 PIR1 PIR2 .... PIR15 (smaller number PIR first)
STEP 15 Turn on the SV8500 server.
• Turn on "Power" switch (press the right side of the switch) on the Power module.
STEP 16 Make sure that the system is placed in normal operation by checking the following lamps.
• "PWR" lamp on the CPU card lights green.
• "ON LINE" lamp on the CPU card will change as follows:
(1) OFF (2)FAST flash (3)SLOW flash (4)steady ON
STEP 17 Set the clock information referring to
[End]
CHAPTER 2
"How to Adjust Date and
– 72 –
Operations of SV8500 Server
Time."