How To Adjust Date And Time - NEC Univerge SV8500 Operation And Maintenance Manual

For the details, refer to UNIVERGE SV8500 Data Programming Manual - Business.
Note:
Activation of time-synchronization (SNTP) service is limited to once a day. Thus, if ANTPL command is
Note:
used to change the start time for SNTP service after SNTP service is already active for that day, the
change takes effect from the following day. Activate the SNTP service manually by pressing the Execute
button when immediate time adjustment is needed.
Example:
1) Existing start time for SNTP service is 01:00.
2) At 03:00, ANTPL command is used to change the start time from 01:00 to 05:00.
3) The next start time for SNTP service is 05:00 on the next day.

1.3 How to Adjust Date and Time

When the system is rebooted, the clock information will also be reset. Adjust the date and time by one of
the following procedures after system reboot.
(1) When Not Using SNTP Server
STEP 1 Execute ATIM/ATIMN command.
STEP 2 Set the current date and time.
STEP 3 Click on "Set" button to apply the date and time.
(2) When Using SNTP Server
STEP 1 Execute ANTPL command.
STEP 2 Click on "Execute" button to synchronize the date and time of the specified SNTP server.
CHAPTER 2
– 43 –
Operations of SV8500 Server