Cmod Change Of System Mode - NEC Univerge SV8500 Operation And Maintenance Manual

Hide thumbs Also See for Univerge SV8500:
Table of Contents

Advertisement

CMOD: Change of System Mode
1. Functional Outline
This command is used to execute ACT/STBY change of the processor (CPU)/TSW and display the status of
CPU/TSW/PLO/F-BUS.
A System failure may occur if this command is used in an improper way. Pay close attention when oper-
Note:
ating this command.
2. Parameters
Input Data
TYPE:
DEVICE:
SW:
SYSTEM:
When the status of TSW is ACT, "Make Busy of TDSW" for TYPE is invalid. Select "Change Operating
Note 1:
Mode" to change the status of TSW from ACT to STBY before executing "Make Busy of TDSW".
This parameter appears only when "1" is selected in TYPE.
Note 2:
This parameter appears only when "2" is selected in TYPE.
Note 3:
Output data
<Upper field>
Parameter:
CPU
TSW
PLO
PIR (Available since FP85-104 S1E)
MISCR (Not used)
Type of Process (1,2)
1/2=Change Operating Mode/Make Busy of TDSW
Device to be changed (1,2)
1=CPU
2=TSW
Type of Switch
Note 3
1=TSW (fixed)
System of Switch (0,1)
0/1=System 0/System 1
CHAPTER 7
Note 2
Note 3
,
Note 4
Note 5
– 746 –
Maintenance Commands
Note 1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fp85-104 s1e

Table of Contents