How To Set The Current Date And Time - NEC Univerge SV8500 Operation And Maintenance Manual

1. HOW TO SET THE CURRENT DATE AND TIME

1.1 General
System clock can be manually or automatically adjusted as shown below. For automatic adjustment, an SNTP
server is required.
ATIM/ATIMN
PCPro
1.2 Programming to Specify How to Set Date and Time
(1) When Not Using SNTP Server
STEP 1 ATIM/ATIMN
Date, Time, and Day Light Savings (Start/End) can be specified on this command. By pressing the "Set"
button on the command, the specified Date and Time will be applied to the system that is in operation.
(2) When Using SNTP Server
STEP 1 ATIM
When using Day Light Savings, set the data by using ATIM command.
STEP 2 ANTPL (SNTP Setting)
By this command, set time for time-synchronization (SNTP) service as well as an SNTP server by us-
ing the domain name or IP address. Time adjustment will be automatically performed on a daily basis.
IP Address of the DNS Server must be set using the ADTM command when SNTP server is specified
the domain name.
Figure 2-1 How to Set the Current Date and Time
manual adjustment
SV8500 server
time-synchronization
CHAPTER 2
automatic adjustment
SNTP server
– 42 –
Operations of SV8500 Server
ANTPL