NEC Univerge SV8500 Operation And Maintenance Manual page 116

installation finish!
root@(none):~#
root@(none):~# halt
......
When the system is FP85 104 S1 Issue 3 or earlier, execute reboot command instead of halt command.
Note:
installation finish!
root@(none):~#
root@(none):~# reboot
......
STEP 13 Remove the installer CD-ROM from the CD/DVD drive.
When halt command is executed in Step 12, turning off the power of PC and ejecting CD-ROM from PC
Note:
can be performed automatically. Turning off the power of PC begins approximately 30 seconds later
when halt command is executed.
If the reboot command is executed in Step 12. When boot prompt appears, remove the installer CD-ROM
Note:
from the CD/DVD drive.
boot:
STEP 14 If the reboot command is executed in Step 12, turn OFF the PC.
STEP 15 If you modified the BIOS setting (booting drive priority) at STEP 3, restore to the previous set-
ting as needed.
[End]
CF card initialization is now finished. Go on to the initial installation procedures with PCPro Tools. Refer
to the "Installation Manual"
for the initial installation procedures.
If you use a PC whose writing speed to CF card is slow, an error may occur.
Note:
• If the process ends up showing error, the CD-ROM will not be ejected automatically; remove man-
ually.
• If "CF is NOT found..." is displayed, the PC is failed to recognize the card. Try this on other PC.
"CHAPTER 5 SYSTEM STARTUP"
– 69 –
CHAPTER 2 Operations of SV8500 Server
Installation is finished.
Execute Shut Down.
Installation is finished.
Execute Reboot.
boot prompt.
"1.2 Program Install to CF Card"