Atrf Assignment Of Traffic Measurement Order - NEC Univerge SV8500 Operation And Maintenance Manual

ATRF: Assignment of Traffic Measurement Order
1. Functional Outline
This command is used to assign and delete traffic measurement programs. A request for traffic measurement is
performed when a traffic measurement instruction has been assigned by this command. The collected traffic
measurement data can be stored on the HD of the PCPro, that can be designated on the basis of the traffic
measurement type.
Assign the following when setting Traffic Measurement for Terminal and Route Traffic (ATRF), Connec-
Note:
tion Route Traffic and IP Service Traffic:
ASYD, SYS1, INDEX47, bit 0= (0/1=CCS/Erlang)
bit 7=1(Execute Traffic Measurement)
2. Parameters
Input Data
TYPE:
DATA
1 Terminal Traffic
3 Station Peg Count
5
Route Peg Count
8
UCD Route Peg Count
10 UCD Station Peg Count
17 CS Peg Count
19 Connection Route Traffic Note 3
21
IP Service Traffic
Port:Traffic Information Output Terminal Number (0-7:IOC, 8:LAN, 9:NMS)
Interval:Output interval (0, 30-120)
Assign the data (30-120) in ten minute increments. When assigning 0 (available when any of TYPE 3-22
is selected), instead specify your desired output time in the "Output TIME" parameters below.
Start TIME Note 1
End TIME
Note 1
Output TIME:This data entry is valid only when INTERVAL=0.
Start RT:Start External Route Number (available when TYPE 2/5/8 is selected)
Type of Traffic Measurement (1-22) (See Table 7-1.)
Table 7-1 ATRF - Type of Traffic Measurement Explanation
MEANING
CHAPTER 7
DATA
2 Route Traffic
4 ATT Peg Count
6
Service Peg Count
9
UCD Group Peg Count
15 ATT Answering Peg Count Note 2
18 Connection Route Peg Count Note 3
20
IP Service Peg Count
22
SIP Terminal Peg Count
– 709 –
Maintenance Commands
MEANING