Ip Related System Messages And The Reasons - NEC Univerge SV8500 Operation And Maintenance Manual

1.3 IP Related System Messages and the Reasons

This section explains the situation when system messages shown below appeared with relation to the IP.
Because of the system characteristic, there will be faults related to system side equipment and other faults
(including the fault occurred on the network). Refer to system message and detailed data for the best treat-
ment. In a certain condition, alarm may not be released or the failure may not be solved by the operation
of procedure shown below.
FNC=02H, INF=04H, FLT=04H (Exceed number of maxi-
mum connection)
FNC=03H, INF=01H, FLT=02H (Excessive RTP packet
33-R
loss)
FNC=05H (Sequence error), INF=01/02H, FLT=xxH
FNC=05H, INF=04H, FLT=02H (Command re-send error)
FNC=02H, INF=01H, FLT=01H (Fall out of Ether (LAN)
cable)
FNC=05H (Sequence error), INF=01/02H, FLT=xxH
33-S
FNC=05H, INF=03H, FLT=01H (Health check error)
FNC=05H, INF=04H, FLT=02H (Command re-send error)
Table 4-1 IP related System Messages
System Messages
CHAPTER 4
IP Related System Message and Its
Reason (33-R) on page 537
IP Related System Message and Its
Reason (33-S) on page 539
– 536 –
Fault Repair Procedures
Reference