[Cme0] Initialization/Changeover Of Backup Cpu System - NEC Univerge NEAX 2000 IPS Command Manual

COMMAND CODE TITLE:
E0
FUNCTION:
This command allows the maintenance personnel to reset the system with the CAT.
PRECAUTION:
If the setting data (Month, Day and Time) is different from the current time of the system clock set by
CM02, any request to initialize the system is not accepted and "DATA ERROR" is displayed.
ASSIGNMENT PROCEDURE:
ST + E0Y + DE
DATA TABLE:
Y
No. MEANING
2 System Initialization
5 Desired FP/AP Initial-
ization
6 Manual changeover of
Backup CPU system
(For test)
[Series 3200 R6.1
(R6.1)]
NOTE 1: For the Data "MMDDHHmm", enter the Month, Date, and Time (hour and minute) of the
time, as shown below.
MM : Month (01 (Jan.)-12 (Dec.))
DD : Date (01-31)
HH : Hour (00-23)
mm : Minute (00-59)
NOTE 2: After assigning the first data, "INITIAL?" is displayed. To changeover the active/stand by
MP, assign the current time while "INITIAL?" is displayed.
"HARD WARE ERROR" is displayed when there is no stand by MP for changeover.
INITIALIZATION/CHANGEOVER OF BACKUP CPU SYSTEM
TYPE OF INITIALIZATION
+
(2/4 digits)
TYPE OF INITIALIZATION
No. MEANING
2000 MP Reset
00 FP/AP number 00
31 FP/AP number 31
3600 Active/Stand by
changeover
DATA
+ DE +
(8 digits)
SETTING DATA
DATA
MM Current time dis-
DD played on D
HH ATTCON
mm
To request the initial-
ization immediately.
Current time dis-
played on D
ATTCON
To request the
changeover immedi-
ately.
– 714 –
+ EXE
: Initial Data
RELATED
COMMAND
MEANING
CM02
term
/
CM02
CM05
NOTE 1
CM02
term
/ CM43 Y=4
CMEC Y=5
NOTE 1
NOTE 2
NWA-008844-001 Rev.5.0
CME0
91ch3008.fm