Dpkg Display Of Setting Port Package - NEC Univerge SV8500 Operation And Maintenance Manual

DPKG: Display of Setting Port Package
1. Functional Outline
This command is used to display the circuit card name accommodated in each Group of a specific UNIT.
When using this command, make sure that each circuit card's related database file has already been in-
Note:
stalled to the PCPro. (See the FLINST command for more information.)
DPKG command should be run during low traffic only.
Note:
2. Parameters
Input Data
MG:
UNIT:
Buttons
Get:
Close:
When the Input Data above is entered and the Get button is pressed, the related circuit card name is dis-
Note:
played on a Group basis. However, if the name is not found for some reason, the following mark may
appear in the relevant display field.
• #
• ##
• ###
• *
Module Group Number [00-07]
Unit Number [0-3]
Get information on mounted circuit cards.
Exit this command.
Unidentifiable firmware type.
Data not found in FMID (database).
Group data not assigned.
Circuit card name not found (for the card is in make-busy state, etc.).
CHAPTER 7
– 823 –
Maintenance Commands