NEC Univerge SV8500 Operation And Maintenance Manual page 40

1.3 Registration Destination of IP Devices/Stations
Here lists IP addresses of Telephony Server to be assigned to each IP device/station as its registration destina-
tion. The IP address varies depending on several conditions, consisting of PH kind that handles the device/sta-
tion, protocol mode in which the device/terminal operates, and Telephony Server's configuration. The table
below specifies the IP address necessary for each IP device/station, covering all the conditions.
Category
CPU
PH
Note 1
Internal PHE
TP
Internal PHI
SP-
PHD
MPH
SP
SP-
PHI
-
Device/terminal names in the table are general terms. If you want to know formal names of them, refer to
Note:
"TERMS IN THIS MANUAL" at the top of this manual.
In this manual, Telephony Server may be referred as "DRS" or "SIP server" depending on the registration
Note:
destination. IP address of DRS/SIP server is, however, same as that of Telephony Server. Therefore, IP ad-
dress of DRS/SIP server is also as the table above.
Telephony Server has two parts of processors on its CPU, TP and SP. For the information about it, refer
Note 1:
to "Structure of Telephony
Protocol
mode
Analog 2MC
Proprietary MC&MG-COT (MC part)
Protocol mode IP-BS
VS32
MC&MG-COT (MG part)
MG-COT
Proprietary
MG(BRI)
Protocol mode
MG(PRI)
MG(SIP)
Proprietary
IP terminal
Protocol mode
SIP mode SIP terminal
Proprietary MC&MG-COT (MG part)
Protocol mode MG(BRI)
MG-COT
MG(BRI)
MG(PRI)
SIP mode
MG-T1(SIP)
8LC Card
VS32
WLAN Handset (MH Series)
SIP mode
Standard SIP Terminal
Server".
Device/Station
Note 2
Note 3
– INT-3 –
IP Address of
Registration Destination
Single
Configuration Configuration
LAN1 (ACT) LAN1 (ACT)
Note 4 Note 4
LAN1 (ACT) LAN1 (ACT)
Note 4 Note 4
LAN1 (ACT) LAN1 (ACT)
Note 4 Note 4
LAN1 (ACT) LAN1 (ACT)
LAN1 (ACT) LAN1 (ACT)
Note 4 Note 4
LAN1
LAN1 (ACT) (System #0)
/(System #1)
LAN1 (ACT) LAN1 (ACT)
Dual