Pir Face Layout - NEC Univerge SV8500 Operation And Maintenance Manual

1.1

PIR Face Layout

The figure below shows the slot configuration and the condition of mounted circuit card types for PIR.
PIR 0 (1-IMG)
PIR other than PIR0 (1-IMG)
TSW will be mounted on the Slots 13 and 14 of PIR0 (1-IMG only).
Note 1:
Faulty switch settings may cause system down, always handle it with care.
Note 2:
Corresponding alarm lamp is lit and system message is outputted when replacing the circuit card. Release
the alarm when circuit card replacement has completed. All system messages will be deleted when alarm
is released by the RALM command, read the system messages using the DFTD command when the system
messages are needed.
CHAPTER 5
Figure 5-1 Circuit card mounting of PIR
00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22
Line/Trunk Cards
16 16 16 16 16 16
LT Connector Accommodations
00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22
Line/Trunk Cards
16 16 16 16 16 16
LT Connector Accommodations
– 552 –
Operation Procedure for System with PIR
Line/Trunk Cards
32 32 32 16 16 16 16 16 16 32 32
LT Connector Accommodations
Line/Trunk Cards
32 32 32 16 16 16 16 16 16 32 32
LT Connector Accommodations
Slot No.
Available Card Type
Number of Ports
Card Color
Slot No.
Available Card Type
Number of Ports
Card Color