NEC Univerge SV8500 Operation And Maintenance Manual page 787

Readout or input data are different depends on Parameter Type. The data in each Parameter Type are shown
below.
<Deleting data, Original data (for copy), Destination Copy, Original data (for move), Destination Move>
• Parameter Type=STN is selected, read out or input the following data:
TN:
STN:
Phone book Data Num:
• Parameter Type=TELN(LDM) is selected, read out or input the following data:
UGN:
TELN(LDM):
Phone book Data Num:
• Parameter Type=TELN(NDM) is selected, read out or input the following data:
UGN:
TELN(NDM):
Phone book Data Num:
• Parameter Type=LENS is selected, read out or input the following data:
LENS:
Phone book Data Num:
Buttons
Get: Read out the data.
Execute: Start the process.
Exit: Exit this command.
Tenant Number
Physical Station Number (0-9, #, * [Maximum 6 digits])
Number of Local Phone book Data (0-100) is displayed.
User Group Number (1-255)
Telephone Number (0-9, #, * [Maximum 16 digits])
Number of Local Phone book Data (0-100) is displayed.
User Group Number (1-255)
Telephone Number (0-9, #, * [Maximum 16 digits])
Number of Local Phone book Data (0-100) is displayed.
Line Equipment Number
Number of Local Phone book Data (0-100) is displayed.
– 740 –
CHAPTER 7 Maintenance Commands