NEC Univerge SV8500 Operation And Maintenance Manual page 821

Select ALL TYPE or RANGE TYPE in the drop-down list to set the range of registered data to be read out
and listed in Data field.
• ALL TYPE:
• RANGE TYPE: Registered data is to be listed specifying the range by TN and ACC.
TN (Tenant Number): Set the range by entering START TN and END TN [1-63].
ACC (Access Code): Set the range by entering START ACC and END ACC [Up to six digits].
Data
ALL SELECT
Place a checkmark to delete all the listed data.
Indicate from CNT to SRV
Place a checkmark to set the parameters CNT through SRV are to be listed.
Regardless of the checkmark ON/OFF selected, STATUS field is always displayed.
Note:
<Details on parameters listed>
CNT:
TN:
ACC:
CI:
SRV:
SID:
SIDA:
NND:
NND1:
FPC:
STATE:
NO1:
NO2:
KIND:
PNO:
A/G:
LGRT:
2nd DT:
AH:
All the registered data is to be listed.
Number of lines Note 1
Tenant Number
Access Code
Connection Status Index
Kind of Service
Service Index
Service Index A
Necessary Digit
Necessary Digit for Speed Calling
Fusion Point Code
Hotel Service Code
Kind of Assignment Number
Kind of Assignment Number
Kind of Function
Pattern Number for AOSP command
Admin/Guest
Logical Route Number
Second Dial Tone
Authorization Code
CHAPTER 7
– 774 –
Maintenance Commands