Rinz Route Initialize - NEC Univerge SV8500 Operation And Maintenance Manual

RINZ: Route Initialize
1. Functional Outline
This command is used to initialize virtual trunk data used for Protocol Handler (PH) cards. When in-progress
virtual trunk is not able to recover from a fault, this command is used to disconnect the in-progress call forcefully
due to the recovery.
2. Parameters
Input data
RT: Route Number
TK: Trunk Number (1-255)
Details of a color:
Not Assign: GRAY (Status/Result2: 0)
Idle: WHITE (Status: 1)
Busy: RED (Status: 2)
Initialize Start: YELLOW (Result: 1)
Initialize Success: GREEN (Result2: 1)
Initialize Failure: BLUE (Result: 2)
Initialize Executing: YELLOW (Result2: 2)
The numbers shown in brackets are used for printout data.
Note:
STATUS indicates the trunk status.
Result indicates the result for the initial setting request.
Result 2 indicates the result for the initial setting execution.
CHAPTER 7
– 898 –
Maintenance Commands