F Fusion Health Check Report (Temporary/Permanent) - NEC Univerge SV8500 Operation And Maintenance Manual

36-F: Fusion Health Check Report (Temporary/Permanent)
Default Alarm
SUP
[36-F] Fusion Health Check Report (Temporary/Permanent) is output when the timeout of Fusion Health Check
is detected.
This message is of two types: Temporary and Permanent.
The temporary failure message is displayed when the timeout of Fusion Health Check is detected.
The permanent failure message is displayed when the timeout of Fusion Health Check has been detected ten
consecutive times.
Fusion Health Check is executed by assigning the system data [ASYDL/ASYDN: SYS1, Index 530].
Also, the system message [36-F/36-K/36-T] is output when the timeout of Fusion Health Check is detected, by
assigning the system data [ASYDL/ASYDN: SYS1, Index 534]. Refer to Office Data Specifications for the de-
tail.
By default, the message is defined to be output at the first timeout; this output timing can be changed by
Note 1:
the system data [ASYDL/ASYDN:SYS1, Index 656, Bits 0-3].
While [36-F] Fusion Health Check Report (Temporary/Permanent) has been output for the temporary tim-
Note:
eout of Fusion Health Check, if Release Alarm is executed, the Error Counter will be cleared. Therefore, if
the timeout of Fusion Health Check is detected after Release Alarm is executed, the [36-F] Fusion Health
Check Report (Temporary/Permanent) will be output for the temporary timeout of Fusion Health Check.
Also, if Release Alarm is executed when the timeout of Fusion Health Check is detected, [36-K] Fusion
Health Check Report (Recovery) will not be output.
[36-T] Fusion Health Check Report (Permanent) can be output instead of [36-F] Fusion Health Check Re-
Note:
port (Temporary/Permanent) for the permanent timeout of Fusion Health Check when the system data
[ASYDL/ASYDN: SYS1, Index 655, Bit 0-2 = 1] is assigned, which can be specified on a Fusion type basis
as shown on the table below.
When [36-F] Fusion Health Check Report (Temporary/Permanent) or [36-T] Fusion Health Check Report
Note:
(Permanent) is output, if there is no alternate route, a call cannot be made to the node where a failure is
occurring until [36-K] Fusion Health Check Report (Recovery) is output. However, a call can be made
within the same node or node where a failure is not occurring.
When [36-F] Fusion Health Check Report (Temporary/Permanent) or
Note:
(Permanent) is output, [36-K] Fusion Health Check Report (Recovery) is output when released.
Default Grade
-
Fusion Type
P2P
Grade Modified
Target Device
External LAN
External LAN
– 501 –
CHAPTER 3 System Messages
Lamp Modified
-
Note 1
Remark
Except for Ether
Link Disconnection
Fusion Health Check Report
[36-T]