Selecting The Dialing Mode; Setting The Flash Time; Setting The Pbx Dial Code - NEC AT-55P User Manual

Selecting the Dialing Mode

Set the Dialing Mode Switch on the rear of the telephone to either DP (Pulse) or MF (Tone) to
select the signaling type. The signaling type depends on the requirements of the PBX to which the
telephone is connected.

Setting the Flash Time

The correct hook flash timing depends on the requirements of the PBX to which the telephone is
connected.
1. Ensure the phone is idle.
2. Dial *41 *.
3. Dial 00 to 06 to select from the following hook flash timings.
00: 95ms
04: 270ms
4. Dial #.
5. After the setting is completed, the setting time (e.g.300) is shown on the LCD for 15
seconds.

Setting the PBX DIAL Code

When this telephone is installed as a PBX extension, a trunk access code is often required to
precede external numbers that are dialed. The PBX DIAL key can automatically insert the PBX
trunk access code at the front of a dialed number, when dialing from a One-Touch key, the IN List
(Caller ID), or when Preview Dialing.
The PBX trunk access code may differ from site to site, according to how the PBX is configured.
Set the PBX DIAL code with following steps.
To set or change the PBX DIAL code:
1. Ensure the phone is idle.
2. Dial * 0 *.
3. Dial the PBX trunk access code 0 to 9. (Default=not assigned.)
4. Dial #.
To clear the PBX DIAL code:
1. Ensure the phone is idle.
2. Dial * 0 * #.
01: 100ms 02: 120ms
05: 300ms 06: 600ms (Default)
03: 180ms
7
INITIAL SETUP