Assigning An Ip Address Using Bootp; Assigning An Ip Address Using The Cli - 3Com V7122 User Manual

When implementing a V7122 gateway with two modules, repeat Steps 3 to 5 for the
6
second module; otherwise, skip to Step 7.
Disconnect your PC from the gateway or from the hub / switch (depending on the
7
connection method you used in
Reconnect the gateway and your PC (if necessary) to the network.
8
Restore your PC's IP address and subnet mask to what they originally were. If
9
necessary, restart your PC and re-access the gateway using the Embedded Web Server
with its new assigned IP address.

Assigning an IP Address Using BootP

BootP procedure can also be performed using any standard compatible BootP
server.
You can also use BootP to load the auxiliary files to the gateway (See
Configuration Files
To assign an IP address using BootP:
Open the BootP application (supplied with the gateway software package).
1
Add client configuration for the gateway that you want to initialize, see
2
Use the reset button to physically reset the gateway causing it to use BootP; the gateway
3
changes its network parameters to the values provided by the BootP.
Repeat Steps 2 and 3 for the gateway 's second module (if used).
4

Assigning an IP Address Using the CLI

First access the CLI using a standard Telnet application or using a serial communication
software (for example, HyperTerminalTM) connected to the RS-232 port (if supported) (see
A ccessing the CLI). Then assign the gateway an IP address (see
1
V7122 Gateway User Guide
Step 1).
Parameters).
Adding Clients.
Assign an IP Address).
61