Viewing Call Charge Information - Avaya Communication Manager Administrator's Manual

6. In the Frequency field, type 50/12.
This is the signal frequency (in kHz). The frequency you will use depends on what the circuit
pack you use is able to accept. See
7. In the Administrable Timers section, set the Outgoing Glare Guard timer to 5 seconds.
8. Press Enter to save your changes.
9. You also need to ensure that the values of the Digital Metering Pulse Minimum,
Maximum and Value on the DS1 Circuit Pack screen are appropriate to the values offered
by your service provider. See
Related topics
For more information about AOC and PPM, see "Call Charge Information" in Feature
Description and Implementation for Avaya Communication Manager, 555-245-205.

Viewing Call Charge Information

Avaya Communication Manager provides two ways for you to view call-charge information: on a
telephone display or as part of the Call Detail Recording (CDR) report. From a display, users
can see the cost of an outgoing call, both while the call is in progress and at the end of the call.
Instructions
In this example, we administer extension 5040 to be able to view the charge of a call in
progress. The charges will appear in currency units (in this case, Lira) on the user's telephone
display.
1. Type change trunk-group 2. Press Enter. Click Next Page until the Trunk Features
section appears.
2. In the Charge Conversion field, type 200.
This indicates that one charge unit sent from the service provider is equal to 200 units, in
this case, Lira.
3. In the Decimal Point field, type none.
4. In the Charge Type field, type Lira.
5. Press Enter to save your changes.
Tone Generation
DS1 Circuit Pack on page 921 for more information.
Viewing Call Charge Information
on page 1594 for more information.
Issue 2.1 May 2006 637