Avaya Communication Manager Administrator's Manual page 931

MMI Cabling Board
This field appears only if the MMCH field is y on the System-Parameters Customer-Options
screen.
Valid entries
slot address
(cabinet, carrier, slot)
MMI Interface
This display-only field appears if the MMCH field is y on the System-Parameters
Customer-Options screen and there is a value in the MMI Cabling Board field.
Name
Use this field to assign a significant, descriptive name to the DS1 link. Avaya recommends
putting the vendor's circuit ID for the link in this field, because that information helps you
troubleshoot problems with the link, but you could also use this field to indicate the function or
the destination of this DS1 facility. In that case, put the DS1 link circuit ID in the Name field of
the trunk group associated with this link.
Valid entries
1 to 15 characters
Peer Protocol
This allows you to administer the peer level protocol that will operate in a private network. This
field appears if the Interface field is peer-master or peer-slave. To enter Q-SIG, the Basic Call
Setup field on the System-Parameters Customer-Options screen must be y
.
Valid entries
Q-SIG
TTC
Usage
Enter the slot location (cabinet, carrier, slot) of the multimedia interface
circuit pack that is connected to the Expansion Services Module
(ESM).
Usage
Enter a name for the DS1 link.
NOTE: Avaya BRI stations support ASCII characters only. They do not
support non-ASCII characters, such as Eurofont or Kanafont. Therefore,
if you use non-ASCII characters in any Communication Manager Name
field, such characters will not display correctly on a BRI station.
Usage
This implements QSIG Network Basic Call.
For private networking. Requires a Digital Trunk (Japan 2 MB TTC)
(TN2242) circuit pack.
DS1 Circuit Pack
Issue 2.1 May 2006 931