Avaya Communication Manager Administrator's Manual page 969

Multimedia Data Conference Activation
If you enter this FAC from any voice station that is participating in a multimedia call, it will alert
Avaya Communication Manager that you want to enable data collaboration with the other
parties on the call. If you enter this FAC a second time, it will give denial treatment (since a
collaboration session is already active). This FAC only applies to voice stations on servers
equipped with ESM adjuncts.
Multimedia Data Conference Deactivation
If you enter this FAC from the telephone that enabled data collaboration on a multimedia mode
call, it will deactivate the data session and revert to a voice and video call. If a user enters this
FAC while participating in a data-collaboration multimedia call that the user did not initiate, the
system responds with denial treatment.
Multimedia Multi-Address Access Code
The multimedia multi-address access code is similar to the multimedia call access code. It
allows origination of a multimedia call from a voice station. It is used when the destination being
dialed requires a different address for each of the 2 B-channels. For example, ISDN-BRI
provided by a Central Office is provisioned with separate listed directory numbers for each
B-channel. In order to make a 2B multimedia call to such a device, two sets of addresses must
be entered.
Originating a multimedia call with the multimedia multi-address access code will originate a call
according to the Default Multimedia Parameters selected on the Feature-Related
System-Parameters screen.
Multimedia Parameter Access Code
This FAC can be entered by any voice station to indicate to Avaya Communication Manager
that you want to initiate a multimedia mode call with a specific bearer capability. This FAC would
be followed by a 1 or 2 to indicate the following parameter selections respectively: 2x64
(unrestricted initial system default), 2x56 (restricted).
Feature Access Code
Issue 2.1 May 2006 969