Avaya Communication Manager Administrator's Manual page 412

Setting Up Telecommuting
4. Set the following fields to y.
Extended Forwarding All
●
Extended Forwarding B/DA
●
This allows you to change the forwarding of all your calls from an off-site location.
5. Set the Restrict Call Fwd-Off Net field to n. Press Enter.
This allows your users to forward calls off-site.
Interactions
Bridged Appearance
●
When the pound key (#) is pressed from a bridged appearance immediately following any of
this feature's four feature access codes (FACs), the system assumes that the currently
active bridged extension will be administered. The station security code of the currently
active bridged extension must be entered after the initial # to successfully complete the
command sequence.
If the station has only bridged appearances, the station's extension must be dialed after the
FAC to successfully complete the command sequence, since the station's extension is not
associated with any appearances.
Distributed Communications System
●
Assign a different telecommuting access extension for each server running Communication
Manager. You can use Extended User Administration of Redirected Calls from any of the
DCS nodes, but you must dial the extension of the node on which your station is defined
before dialing the FAC.
Tenant Partitioning
●
The telecommuting access extension is always automatically assigned to Tenant Partition
1, so it can be accessed by all tenants.
The tenant number of the extension being administered must be accessible by the tenant
number from which the Extended User Administration of Redirected Calls FAC is dialed or
the request is denied. If the FAC is dialed on site, the tenant number of the station or
attendant must have access to the tenant number of the extension administered. If the FAC
is dialed off site, the tenant number of the incoming trunk must have access to the tenant
number of the extension administered.
412 Administrator Guide for Avaya Communication Manager