Avaya Communication Manager Administrator's Manual page 876

Screen Reference
Endpoint Type
Used with X.25 Data Modules. An endpoint type is a type of packet switched data endpoint that
uses X.25 call control procedures. The X.25 Endpoint connects to external ports on the PGATE
board and to the TDM bus via a DS1 trunk. Ports connected to the adjunct endpoint can be
either DTEs or DCEs. The type of endpoint (DTE or DCE) is administrable on the
screen.
Valid entries
adjunct
Error Logging
Used with X.25 Data Modules.
Valid entries
y/n
Establish Connection
Used with X.25, Point-to-Point, and Processor Interface (used with DEFINITY CSI only) data
modules. See Administration for Network Connectivity for Avaya Communication Manager,
555-233-504, for more information.
Highest PVC Logical Channel
A display-only field used with X.25 Data Modules. Appears when the Permanent Virtual
Circuit field is y. Specifies how the above endpoint type acts.
Valid entries
1 to 64
IP Address Negotiation
Used with Point-to-Point data modules. Does not appear for S8700 Series IP-Connect. See
Administration for Network Connectivity for Avaya Communication Manager, 555-233-504, for
more information.
876 Administrator Guide for Avaya Communication Manager
Usage
Mandatory entry.
Usage
Enter y to record X.25 protocol errors in the hardware error log. See the
maintenance manual for your model for more information about error logs.
Usage
Indicates that 1 to 64 Logical Channels are allowed on this port.
Data Module