Avaya Communication Manager Administrator's Manual page 355

ESM Installation
Figure 155: Typical Multimedia Call handling ESM Connections
Figure notes:
1. Port B Y-cable connector to a TN787
multimedia interface (MMI) circuit pack
2. Port A Y-cable connector to a TN2207
PRI circuit pack
3. 25-pair Y-cable
4. 356A adapter
Use the following procedure and
page 355 to connect to the ESM equipment:
1. Install the TN2207 primary rate interface (PRI) circuit pack and the TN787 multimedia
interface (MMI) circuit pack in the port carrier of the server for Avaya Communication
Manager.
Note:
These two circuit packs should be co-located in the cabinet since they must be
Note:
connected by a Y-cable on the back plane of the Avaya DEFINITY Server.
2. Record the circuit pack locations.
3. Connect the ESM Y-cable as shown.
4. Administer the DS1 Circuit Pack
ESM T.120 Server Administration
5. Configure the ESM adjunct.
5. D8W cord connected to 356A adapter S/B
port 8
6. Extended services module (ESM)
7. Port B on compatible primary rate
interface (PRI) card
Typical Multimedia Call handling ESM Connections
screen and the Signaling Group
on page 365).
Multimedia Call Handling
on
screen for the ESM (see
Issue 2.1 May 2006 355