Avaya Communication Manager Administrator's Manual page 366

Managing MultiMedia Calling
4. Set the Name field to ESM DS1.
5. Set the Bit Rate field to 2.048.
The TN2207 DS1 must have a bit rate of 2.048, even if all other DS1 boards in the system
are operating at 1.544. Verify the 24/32 channel switch on the circuit pack is in the 32
channel position.
6. Set the Line Coding field to hdb3.
7. Set the Signaling Mode field to isdn-pri.
8. Set the Connect field to pbx.
9. Set the Interface field to network.
10. Set the Country Protocol field to 1.
11. Set the CRC field to y.
12. The Idle Code default is 11111111.
13. The DCP/Analog Bearer Capability default is 3.1 kHz.
14. Set the MMI Cabling Board field to xxxxx (where xxxxx is the location of the TN787 MMI
circuit pack recorded in step 2). This must be the slot for port B of the Y-cable.
15. The MMI Interface field ESM appears.
16. Enter add signaling-group next. The Signaling Group screen appears.
Figure 159: Signaling Group screen
add signaling-group n
Group Number
Trunk Group for Channel Selection:
17. Set the Associated Signaling field to y.
18. Set the Primary D-Channel Port field to xxxx16 (where xxxx is the address of the
TN2207 PRI circuit pack, for example: 1B0516).
19. The Max Number of NCA TSC default is 0.
20. The Max Number of CA TSC default is 0.
21. Trunk Group for NCA TSC ____ (leave blank).
22. Trunk Group for Channel Selection____ (leave blank).
23. Logoff the terminal and then log back on the terminal to view your changes.
366 Administrator Guide for Avaya Communication Manager
___
Associated Signaling?
Primary D-Channel:
Supplementary Service Protocol: _
SIGNALING GROUP
Group Type: isdn-pri
Trunk Group for NCA TSC:
___ X-Mobility/Wireless Type: NONE
Page 1 of x
Max Number of NCA TSC: ___
Max number of CA TSC: ___
___