Avaya Communication Manager Administrator's Manual page 902

Screen Reference
BRI LINK/MAINTENANCE PARAMETERS
Country Protocol
Used with World Class BRI data modules. Enter the protocol that corresponds to your
supported initialization and codesets. The Country Protocol must match any
previously-administered endpoint on the same port. The following table lists the valid protocol
entries. For a list of country codes, see the
Country/Area
Australia
ETSI (Europe)
Japan
Singapore
United States (Bellcore National ISDN)
Endpt ID
Used with World Class BRI and NI-BRI data modules. Appears only if the Endpt Init field is y.
This field provides for multipoint configuration conformance to the Bellcore Terminal Initialization
procedures. In these procedures, a multipoint configuration requires that the last 2 digits of the
Service Profile Identifier (SPID) be between 00 and 63 and be binary unique for each endpoint.
This field, combined with the SPID, gives the effective SPID administered into the terminal.
Bellcore ISDN-1 requires that the SPID programmed into the endpoint contain at least 9 digits.
(For example, if the SPID field is 1234, and the Endpt ID field is set to 01, then the SPID
administered on the terminal is 000123401. The three leading zeros are necessary to create a
9-digit SPID.)
Valid entries
00 to 62
902 Administrator Guide for Avaya Communication Manager
Usage
Enter a 2-digit number. Each Endpt ID field must have a unique value for
each endpoint on the same port.
Country code table on page 1514.
Protocol
2
etsi
3
6
1