Avaya Communication Manager Administrator's Manual page 880

Screen Reference
Physical Channel
Used with Netcon and Processor Interface Data Modules. The Physical Channel number is
referred to on associated system forms as the Interface Link number.
Valid entries
01 to 08
01 to 04
Port
Used with 7500, Data Line, Ethernet, Processor/Trunk, PPP, System Port, X.25, and World
Class BRI Data Modules. Specifies a port location to which the data module is connected.
Characters
1-2
3
4-5
6-7
Note:
You can enter x in the Port field to indicate that there is no hardware associated
Note:
with the port assignment (also known as Administration Without Hardware
(AWOH). These stations are referred to as "phantom stations." If this data module
is designated as a secondary data module (Secondary data module set to y) An x
cannot be entered into this field. The port of a primary data module cannot be
changed to x if a secondary data module is administered.
880 Administrator Guide for Avaya Communication Manager
Usage
For Processor Interface Data Modules, enter the 2-digit circuit number of
the Processor Interface port. A multi-carrier cabinet system supports the
use of two Processor Interface circuit packs, the first circuit pack
(mounted in Control Carrier A) supports physical channels or links 01
through 04; the second (mounted in Control Carrier A) supports physical
channels or links 05 through 08. A single-carrier cabinet system supports
one Processor Interface circuit pack and physical channels or links 01
through 04 only.
For DEFINITY CSI configurations. For Netcon Data Modules, enter a
netcon data channel.
Meaning Value
Cabinet 01 to 64 (S8700 Series IP-Connect)
Number
Carrier A to E
Slot Number 0 to 20
Circuit Number 01 to 04 (x.25 circuit pack)
01 to 31 (S8700 Series IP-Connect (tdm, pdm)
configurations)
01 to 16 (ppp for S8700 Series IP-Connect)
01 to 08 (system-port for S8700 Series IP-Connect)
17/33 (Ethernet on S8700 Series IP-Connect)