Ricoh MP C6502SP Field Service Manual page 1323

Hide thumbs Also See for MP C6502SP:

Table of Contents

Error Name/Error Condition/Major Cause/Solution

Operation error caused by abnormalities that are normally undetectable.

An error occurred because the number of records exceeded the

limit for images managed in the service layer of the firmware.

This can occur if there are too many application screens open

on the operation panel.

Logging only.

Error Name/Error Condition/Major Cause/Solution

Application function selection error

The application selected by the operation panel key operated

abnormally (No response, abnormal ending).

Software bug (mainly the application)

• Check the optional RAM, DIMM, boards required by the

application program.

• Check if the combination of downloaded programs are correct.

Error Name/Error Condition/Major Cause/Solution

Application start error

• No application was registered to system within a specified time after

the main power was turned on.

(No application starts/All applications have been terminated

• Application started but cannot be drawn now for some reason.

• Software bug (mainly the application)

• The optional RAM, DIMM, boards required by the application

program. Are not installed correctly.

• Turn the main power off/on.

• Check the optional RAM, DIMM, boards

• Check the combination of programs

• Replace the controller board.

Service Call 900-998

Chapters

Table of Contents