Ricoh MP C6502SP Field Service Manual page 1471

Pro/Office
Pro/Office SP1-001-004 to
111
Pro SP1-950-001 to
100
Pro SP1-951-001 to
100
Pro/Office IMSS setting No.
Pro 6
Pro 7
3. If the symptom still occurs, check the following and replace parts as necessary.
• If the fusing belt is damaged, replace it.
• If the gap between the fusing stripper plate and fusing belt is wider than normal, replace
the fusing unit.
Note: The fusing stripper plate cannot be replaced individually (it can only be attached
and precision-adjusted at the factory).
• If the pressure roller is damaged, replace it.
• If the gap between the pressure roller stripper plate and pressure roller is wider than
normal, replace the pressure roller stripper plate.
• If the rib [A] has come loose, correct the position of the rib as shown.
SP No.
Lead Edge Reg (for each
paper type)
L-Edge Regist Adj (Front) (for
each custom paper)
L-Edge Regist Adj (Rear) (for
each custom paper)
Adjust Image Position of Side
1 With Feed Direction
Adjust Image Position of Side
2 With Feed Direction
SP Name
±9.0
±3.0
±3.0
IMSS setting
±3.0
±3.0
Paper Transport
Value
Value
1469