Ricoh MP C6502SP Field Service Manual page 1362

5. Troubleshooting
Solid line: Trimming area 1st side
Dashed line: Trimming area 2nd side
Step 4-3 You need to make an adjustment with SP1-003-006 so that the average values of [A2]
and [B2] are the same. Refer to 'Reference Information-3' below.
(You can make an adjustment for each paper type with SP1-953-XXX for IMSS setting in a Pro
machine.)
Step 4-4 You need to make an adjustment with SP1-001-003 so that the average values of [C2]
and [D2] are the same. Refer to 'Reference Information-3' below.
(You can make an adjustment for each paper type with SP1-951-XXX for IMSS setting in a Pro
machine.)
Step 5. Adjustment of magnification for back.
Step 5-1 Set A3 or DLT plain paper (63.1-80.0 gsm) in Tray 2 and apply the tray paper settings.
Step 5-2 Print 5 copies of the test pattern Trimming Area (SP2109-003-14) in b/w, Duplex.
Step 5-3 Measure the distance [A] and [B] on all 5 copies and calculate the average.
Step 5-4 You need to make an adjustment with SP2-102-043 so that the average values of [A3]
and [B3] are the same. Refer to 'Reference Information-4' below.
(You can make an adjustment for each paper type with SP2-952-XXX for IMSS setting in a Pro
machine.)
Step 5-5 You need to make an adjustment with SP2-102-044 so that the average values of [C3]
and [D3] are the same. Refer to 'Reference Information-4' below.
(You can make an adjustment for each paper type with SP2-953-XXX for IMSS setting in a Pro
machine.)
Reference Information-1 (Step 2. Skew adjustment for front and back)
1. Check the SP value for the tray being used.
1360