Ricoh MP C6502SP Field Service Manual page 1405

4. Rub the surface of the M0774287 polishing tool (WEB:POLISH:FUSING:ASS'Y) against the
surface of the fusing belt.
• After you finish each section of the fusing belt surface, rotate the fusing gear [A]
counterclockwise and do the next section. Repeat this until you have polished the entire
surface of the belt.
• Make sure to polish both the front and rear sides of the fusing belt. This is because
scratches are generated by the front and rear edges of paper.
1. Surface of polishing tool
2. Fusing belt
• This action will smoothen out any scratches on the fusing belt surface.
• When you rotate the fusing gear [A] counterclockwise, the fusing belt rotates clockwise.
Image Quality
1403