Ricoh MP C6502SP Field Service Manual page 1360

5. Troubleshooting
Back Side (2nd Side)
*The arrow indicates the paper feed direction
Step 3. Image Adjustment for front
Step 3-1 Set A3 or DLT plain paper (63.1-80.0 gsm) in Tray 2 and apply the tray paper settings.
Step 3-2 Print 5 copies of the test pattern Trimming Area (SP2-109-003-14) in b/w, simplex.
Step 3-3 Measure the distance [A] and [B] on all 5 copies and calculate the average.
Step 3-4 You need to make an adjustment with SP1-003-XXX so that the average values of [A] and
[B] are the same. Refer to 'Reference Information-2' below.
(You can make an adjustment for each paper type with SP1-952-XXX for IMSS setting in the Pro
machine.)
Step 3-5 You need to make an adjustment with SP1-001-XXX so that the average values of [A] and
[B] are the same. Refer to 'Reference Information-2' below.
(You can make an adjustment for each paper type with SP1-950-XXX for IMSS setting in the Pro
machine.)
Step 3-6 If you finished the adjustment, check that the value of [C] is more than 4mm.
• If the value of [C] is less than 4mm, a jam may occur because of the fusing stripper pawls.
• So adjust the value of [C] so that it is more than 4mm.
1358