Nvram (Eeprom) On The Bcu - Ricoh MP C6502SP Field Service Manual

Procedure for D135/D136 (Office model) only
Confirm the "Reception Settings" and "Send Settings" correspond with the notes took in Step 9.
Correct the settings, if they are wrong.
23. Print out the SMC data ("ALL") in SP5-990-001, and make sure that it matches with the SMC data
printed out in Step 2 (except for the total counter value).
• The total counter value is reset to "0" when the NVRAM is replaced.
24. Do the self-check Process Control.
25. Do ACC for the copier application program.
26. Do ACC for the printer application program.

NVRAM (EEPROM) on the BCU

Before performing the following procedure, contact your supervisor to obtain information on how to
input the machine serial number in the new NVRAM.
1. Make sure that you have the SMC report (factory settings). This report comes with the machine.
2. Print out the SMC data (SP5-990-001).
3. Turn off the main power switch.
4. Install an SD card into SD card slot #2 and then, turn on the main power switch.
5. Copy the NVRAM data to an SD card (SP5-824-001).
6. Turn off the main power switch, and then unplug the power cord.
7. Replace the NVRAM on the BCU and put back the covers.
8. Plug in the power cord, and then turn on the main power switch.
Select the paper-size system in SP5-131-001 (Paper Size Type Selection).
0: DOM (JAPAN)
1: NA
2: EU
9. Specify the area code in SP5-807-001.
1: DOM (JAPAN)
2: NA
3: EU
4: TWN
5: AA
6: CHN
Main Boards / HDD Unit
937