Ricoh MP C6502SP Field Service Manual page 1470

Hide thumbs Also See for MP C6502SP:

Table of Contents

5. Troubleshooting

1: Feed direction

[A]: Leading edge margin

[B]: Trailing edge margin

The margin at the leading or trailing edge is too narrow, which causes the paper to stick to the

pressure roller stripper plate.

Do the following:

1. Increase the margins the leading/trailing edges (up to a maximum of 10mm).

See page 1367 "Margin adjustment".

• If you adjust the margins without adjusting the image position, parts of the image may not

be printed. To adjust the image position, see Step 2 below.

2. If the symptom still occurs, try adjusting the position of the image at the same time. Change the

value in increments of -0.5mm, up to a maximum width of 10mm.

• Before you make any registration adjustments, make sure that the margin in the direction

you will move the image is wide enough.

Subscan registration adjustments:

Chapters

Table of Contents