Ricoh MP C6502SP Field Service Manual page 1373

[A]: Make sure to use the markings on the FRONT exit rollers. The roller markings at the rear
side are for DLT sized paper only, and do not apply to this.
[B]: Front exit rollers
[C]: Each marking represents 2mm. If the paper edge is lined up with the center marking, this
means the paper is aligned correctly. If the paper edge is lined up with any marking to the
right of center, this means the paper is shifted toward the front. If the paper edge is lined up
with any marking to the left of center, this means the paper is shifted toward the rear.
[D]: Center marking
3. Attach the small bracket [B] to the docking bracket [A] as shown (using the screw hole shown
by the red arrow), which will allow the docking bracket to slide side-to-side. Then, reattach
the docking bracket to the machine.
• If the paper shifts forward (toward the operator side), slide the docking bracket by the
same amount in the same direction. This is to move the Finisher toward the operator side.
Note: Each scale marking represents 2mm.
Ex: Paper is shifted 4mm from center toward the front
Adjustment
1371