Installing An Mx2010 Adapter Card - Juniper MX2010 Hardware Manual

user@host>request chassis adc slot slot-number offline
For more information about the command, see the
Reference.
NOTE: When you issue the request chassis adc slot slot-number offline command, the
FRU loses power, and the system's total power increases.
4. Open the ejector handles outward simultaneously to unseat the adapter card.
5. Grasp the ejector handles, and slide the adapter card about halfway out of the chassis.
6. Place one hand underneath the adapter card to support it, and slide it completely out of the chassis.
7. Place the adapter card on the antistatic mat or into an antistatic bag.
8. If you are not replacing the adapter card immediately, install a blank panel over the empty slot.
Figure 277: Removing an Adapter Card

Installing an MX2010 Adapter Card

An adapter card weighs up to 15 lb (6.80 kg). Be prepared to accept its full weight.
Junos OS System Basics and Services Command
531