3. Using a number 2 Phillips (+) screwdriver, secure the extended EMI cover mounting brackets to the
sides of the card cage by using the four screws provided (two on each side) (see
Figure 264: Installing the Extended EMI Cover Mounting Brackets
4. Orient the cover so that the arrows point up in front of the card cage.
5. Angle the extended EMI cover so that the points at each side fit into the grooves on the EMI cover's
mounting brackets.
6. Tilt the extended EMI cover into place and press firmly until the sides contact the mounting brackets
of the EMI cover.
Figure 174 on page
384).
507