Removing The Mx2010 Extended Cable Manager; Removing The Mx2010 Extended Dc Cable Manager - Juniper MX2010 Hardware Manual

Removing the MX2010 Extended Cable Manager

To remove the extended cable manager:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. To remove the cover, loosen the two captive screws on the extended cable manager cover. Set the
extended cable manager cover aside.
3. Remove the eight screws that secure the extended cable manager to the chassis as shown in
Figure 230 on page 465.
4. Pull the extended cable manager away from the chassis.
Figure 230: Removing the Extended Cable Manager

Removing the MX2010 Extended DC Cable Manager

To remove the extended DC cable manager (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Using a Phillips (+) screwdriver (number 1 or 2), loosen the two captive screws on the DC cable manager.
Figure 231 on page 466):
465