MX2010 DC Power Supply Module LEDs
Each DC PSM (-48 V and 240 China) faceplate contains four LEDs. These LEDs are described in
Table 40 on page
121. Nine bicolor LEDs, labeled 0 through 8 for the nine PSMs, are located in the center
of the craft interface.
The primary input of the PSM is a dual redundant feed, INP0 and INP1. Both feeds are active during
operation, but both feeds might or might not be providing current. In addition, a PSM failure triggers the
alarm LED on the craft interface.
Table 40: MX2010 DC Power Supply Module LEDs
Label
Color
PWR OK
Green
Yellow
–
FAULT
Red
–
INP0
Green
Yellow
–
INP1
Green
Yellow
–
RELATED DOCUMENTATION
MX2010 Component LEDs on the Craft Interface | 31
MX2010 Power System Description | 95
MX2010 DC Power Supply Module (-48 V) Description | 116
State
Description
On
PSM is functioning normally with no alarms.
On
PSM controller is functioning normally.
Off
PSM is not functioning normally or the PSM controller is off.
On
PSM is not functioning normally or the DC input voltage of one or more
feeds is out of range.
Off
PSM is functioning normally or both the DIP switches are set to off.
On
DC input is within required voltage range and the DIP switch is set to on.
On
DC input is detected but voltage is out of range.
Off
DC input to the PSM is not present.
On
DC input is within required voltage range and the DIP switch is set to on.
On
DC input is detected but voltage is out of range.
Off
DC input to the PSM is not present.
121