Installing The Mx2010 Extended Cable Manager - Juniper MX2010 Hardware Manual

3. Grasp the extended DC cable manager, lift up and pull straight out from the DC PDM on the rear of
the chassis.
4. Place the extended DC cable manager into an electrostatic bag and set it aside.
Figure 231: Removing the Extended DC Cable Manager
D

Installing the MX2010 Extended Cable Manager

To install the extended cable manager (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Position the extended cable manager on the studs below the lower card cage.
3. Attach the extended cable manager using eight screws as shown in
4. Replace the cable manager cover, and secure it with the two captive screws.
Figure 180 on page 389):
Figure 180 on page 389.
466