Connecting Power To A Dc-Powered Mx2010 Router With Power Distribution Modules - Juniper MX2010 Hardware Manual

Table 83: Input AC Power Mapping for PDM2 and PDM3
PDM2/Input0 (Left)
PSM9
PSM10
PSM11
–
–
–
BEST PRACTICE:
Source A and Source B, we recommend that you connect them as follows:
Connect Source A to PDM0-left and PDM0-right
Connect Source B to PDM1-left and PDM1-right
RELATED DOCUMENTATION
Powering On a Three-Phase AC-Powered MX2000 Router | 319
Connecting Power to a DC-Powered MX2010 Router with Power
Distribution Modules (-48 V)
WARNING:
from the DC circuit. To ensure that all power is off, locate the circuit breaker on the
panel board that services the DC circuit, switch the circuit breaker to the OFF position,
and tape the switch handle of the circuit breaker in the OFF position.
PDM2/Input0 (Right)
PSM12
PSM13
PSM14
PSM15
PSM16
PSM17
To achieve complete redundancy when you have two power sources, such as
Before performing DC power procedures, ensure that power is removed
PDM3/Input1 (Left)
PSM9
PSM10
PSM11
PSM12
PSM13
PSM14
PDM3/Input1 (Right)
PSM15
PSM16
PSM17
–
–
–
304