Powering Off The Router; Powering Off The Ac-Powered Mx2000 Router - Juniper MX2010 Hardware Manual

Universal routing platform

Hide thumbs Also See for MX2010:

Table of Contents

Powering Off the Router

IN THIS CHAPTER

Powering Off the DC-Powered MX2000 Router | 698

Powering Off the AC-Powered MX2000 Router

After powering off a power supply module (PSM), wait at least 60 seconds before turning

To power off the router:

1. On the external management device connected to the CB-RE, issue the request system halt

both-routing-engines operational mode command. The command shuts down the Routing Engine

cleanly, so the state information is preserved. If the router contains only one CB-RE, issue the request

system halt command.

user@host> request system halt both-routing-engines

2. Wait until a message appears on the console confirming that the operating system has halted. For more

information about the command, see the

3. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to

one of the ESD points on the chassis.

4. Move the AC power switch on the AC PSM faceplate for each AC PSM to the off (O) position.

Table of Contents