Figure 228: Removing the DC Cable Manager
D
SEE ALSO
Installing the MX2010 Standard DC Cable Manager | 368
Installing the MX2010 Standard DC Cable Manager
To install the standard DC cable manager (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Position the DC cable manager over the two slots located on both sides of the DC PDM.
3. Lift the DC cable manager slightly up while inserting the two flanges into the slots on both sides of the
DC PDM.
4. Push down to secure the DC cable manager in place.
Figure 162 on page
369):
463