Juniper MX2010 Hardware Manual page 306

You ground the router by connecting a grounding cable to earth ground and then attaching it to the chassis
grounding points by using two screws. To connect the grounding cable (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
an approved site ESD grounding point. See the instructions for your site.
2. Ensure that all grounding surfaces are clean and brought to a bright finish before you make grounding
connections.
3. Connect the grounding cable to a proper earth ground.
4. Verify that a licensed electrician has attached the cable lug provided with the router to the grounding
cable.
5. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
6. Place the grounding cable lug over one of the grounding points on the rear of the chassis. The upper
pair is sized for UNC 1/4-20 nuts, and the lower pair is sized for M6 nuts.
7. Secure the grounding cable lug to the grounding points, first with the washers, and then with the nuts.
8. Verify that the grounding cabling is correct, that the grounding cable does not touch or block access
to router components, and that it does not drape where people could trip on it.
Figure 125: Connecting the Grounding Cable
RELATED DOCUMENTATION
MX2000 Router Grounding Specifications | 142
Figure 125 on page 290):
290