Mapping Input Power From Ac Power Distribution Modules To Ac Power Supply Modules On Mx2000 Routers - Juniper MX2010 Hardware Manual

Connecting AC Power to an MX2000 Router with Three-Phase Wye AC Power Distribution
Modules | 295
MX2000 AC Power System Electrical Specifications | 173
MX2000 AC Power Cord Specifications | 170
Mapping Input Power from AC Power Distribution Modules to AC Power
Supply Modules on MX2000 Routers
You connect AC power to the router by connecting two AC power cords to each AC PDM. One feed maps
to six PSMs and the other maps to three PSMs.
and Figure 72 on page 186
components of the PDM.
and PDM1/Input1 (MX2010 and MX2020).
AC PDM2/Input0 and PDM3/Input1 (MX2020 only).
Figure 71: Mapping AC Power Distribution Module Input to AC Power Supply Modules (MX2010)
MX2010 System Rear View
IN P1/1_LEFT
PSM PSM PSM PSM
0
1 2
IN P0/0_LEFT
Figure 71 on page 185
shows the mapping for the MX2020. The arrangement matches the internal
Table 64 on page 186
Table 65 on page 187
IN P1/1_RIGHT
PDM1
PSM PSM PSM PSM PSM
3 4 5 6 7 8
IN P0/0_RIGHT
PDM0
shows the mapping for the MX2010
shows the AC PDM input mapping to AC PDM0/Input0
shows the AC PDM input mapping to
185