Remx2K-X8-128G Cb-Re Leds - Juniper MX2010 Hardware Manual

NOTE: Use sheilded CAT5e cable for connecting the AUX, CONSOLE, and MGMT ports.
EEPROM in RE—Stores the field replacement unit (FRU) details of the RE.
EEPROM in CB—Stores the field replacement unit (FRU) details of the CB.
RESET button—Reboots the Routing Engine on the CB-RE when pressed.
ONLINE/OFFLINE button—Makes the Routing Engine on the CB-RE online or offline when pressed.
NOTE: The ONLINE/OFFLINE button must be pressed for a minimum 4 seconds for the
power off or power on to occur.
LEDs—Provide status of the Routing Engine on the CB-RE.

REMX2K-X8-128G CB-RE LEDs

Figure 25: REMX2K-X8-128G CB-RE LEDs
1 2
AUX CONSOLE MGMT
ONLINE
DISK1
DISK2
REMX2K-X8-128G
REMX2K-X8-128G
1 ONLINE LED, OK/FAIL LED, and MASTER LED
—
2 DISK1 and DISK2 LEDs
—
Table 20: REMX2K-X8-128G CB-RE LEDs
Label Color
ONLINE Green
-
1 2
XGE-0
State
Blinking slowly
Blinking rapidly
Off
3 4
LINK
BITS
GPS
UTI
XGE-1 EXTCLK-0 EXTCLK-1 OK/FAIL
3 BITS, GPS, and UTI LEDs
—
4 ONLINE/OFFLINE button
—
Description
Routing Engine is in the process of booting BIOS, and the
host OS.
Routing Engine is in the process of booting Junos OS.
Routing Engine is not online or not functioning normally.
60